HELP!!!!

[Thunderbeard]

Can anyone help me. I have had my last 2 attys "die" on me. First one was a few months old, and just stopped working mid vape so I guess it is fried. The second is only a week or so old. Been working brilliantly, that is until I decided to do a bit of spring cleaning of the atty, you know blowing through it and then draining on kitchen towel. Cleaned all the contacts with tissue. However when I put it back on the battery, its not working. I am vaping a tornado mega tank with 1000mwah extended life battery.  I am desperate for any advice, as I'm stuck at work at the moment, no spare atty in sight till after 7pm, and its only 3 pm now.

Any help or tips i could try would be great.

Dave

[efrenchy]

Did you try to reprime it?

[danwldr]

try pulling the posts up using a paper clip, one of your attys may have pushed it down too far.

[RichJr]

Do try pulling the pin down on the atty just a hair. What happens sometimes is the post gets pushed in to far to make contact with the post on the battery. That would make it seem "dead". The post on the battery can also get pushed in slightly. These both circumstances combined can make things confusing since some atties seem dead and some will work.

[danwldr]

Do try pulling the pin down on the atty just a hair. What happens sometimes is the post gets pushed in to far to make contact with the post on the battery. That would make it seem "dead". The post on the battery can also get pushed in slightly. These both circumstances combined can make things confusing since some atties seem dead and some will work.

thanks rtsjr.